
Loft and roof foam extraction across Stafford and Staffordshire
Open cell spray foam removal in Stafford done right
If a surveyor, lender or buyer has flagged the spray foam in your loft, our open cell spray foam removal in Stafford gets it out cleanly. We cut, scrape and vacuum Icynene, Lapolla and Demilec foam from rafters, tiles and trusses, then check the timbers with a moisture meter before we leave. Open cell foam extraction Stafford homeowners can book the same week, with a written report for your lender.
What's included
What our open cell foam removal includes
Every open cell spray foam removal in Stafford includes the survey, the extraction, the clean-down and the written report. There are no hidden extras for standard lofts. If your job needs specialist access, scaffolding or a second visit, we tell you at quote stage rather than adding it later.
Free loft survey and quote
We inspect the foam, measure depth, check ventilation and take moisture meter readings at three points. You get a fixed written price the same day. The survey takes under an hour and there is no charge, whether you book the removal or not.
Full foam extraction
Open cell foam is cut with an oscillating multi-tool, scraped from rafters, and vacuumed into a spray foam removal vacuum. Stubborn patches are treated with dry ice blasting. A standard 40 square metre loft takes four to six hours from setup to finish.
Dust containment and clean-down
Protective sheeting covers the loft floor and stairwell, and an air scrubber runs throughout. Isocyanate dust and foam fragments are captured at source. When we finish, we vacuum the void and wipe surfaces so the loft is usable straight away.
Timber and moisture inspection
Every rafter and truss is checked with a moisture meter and thermal imaging camera once the foam is off. Damp or rot is photographed and logged. You get a clear summary of which timbers need attention, if any, before you make any repair decisions.
Written removal report
The report includes before-and-after photos, moisture readings and a timber condition summary. It is written for mortgage lenders and surveyors, and we have supplied them for completions across Stafford. You get a digital copy and a printed copy on request.
Service overview
What open cell spray foam removal in Stafford involves
Open cell spray foam removal in Stafford is the controlled extraction of low-density polyurethane foam from roof voids, lofts and timber frames. Unlike closed cell foam, open cell material is soft and spongy, so it comes away in chunks rather than solid blocks. We cut it back with an oscillating multi-tool, prise it off rafters with an industrial scraper, then run a spray foam removal vacuum and air scrubber to capture dust and isocyanate particles before they settle in your home.
Most Stafford jobs we see start with a mortgage lender refusal or a surveyor's report flagging hidden damp behind the foam. Open cell insulation removal Stafford wide is common in 1930s semis around Baswich and Wildwood, where foam was sprayed directly onto felt and battens. If you have been searching for open cell spray foam removal in Stafford near me, we cover the whole town and the surrounding villages, usually with a free loft inspection first.
The service timeline
How our foam removal process works
The process flexes to the condition, but these checkpoints keep decisions clear.
Free loft survey
We inspect the foam, the timbers and the ventilation, and take moisture meter readings at three points on the roof structure. You get a fixed price the same day, not an hourly rate. If the foam is closed cell or the timbers are too far gone, we tell you before you spend a penny.
Containment setup
We sheet the loft floor and stairwell with protective sheeting, tape off the hatch, and set the air scrubber running. This keeps isocyanate dust and foam fragments out of your living space. Expect the van on your drive by 8am and the first cut within the hour.
Foam extraction
Foam comes off with an oscillating multi-tool and industrial scraper, then goes straight into the spray foam removal vacuum. On stubborn patches we switch to dry ice blasting, which freezes the foam so it snaps off timber without gouging the wood. A typical 40 square metre loft takes four to six hours.
Timber inspection
With the foam gone we check every rafter and truss with a moisture meter and thermal imaging camera. Anything reading damp gets photographed and logged. If we find rot, we tell you exactly which timbers need attention and who to call - we do not leave you guessing.
Clean-down and report
We vacuum the whole void, wipe down surfaces, and remove all sheeting. You get a written removal report with before-and-after photos and moisture readings, ready for your lender or buyer. The loft is left clean enough to walk through in normal clothes.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Dry ice blasting machine
Freezes dry ice pellets to shrink and crack foam so it releases from delicate felt and battens without tearing them. Used on older Stafford roofs where scrapers would cause damage.
Spray foam removal vacuum
Captures foam fragments, dust and isocyanate particles at the point of cutting. Keeps the loft air clean and stops debris spreading into the rest of the house.
Oscillating multi-tool
Cuts through open cell foam in tight spaces between rafters and around trusses. The fine blade control means we can cut close to timber without gouging it.
Industrial scraper
Prise larger foam sections off rafters and roof decks once they have been cut free. Used after the multi-tool has broken the foam's grip on the timber.
Thermal imaging camera
Reveals damp patches and cold spots in the roof structure that are invisible to the eye. We use it after extraction to confirm the timbers are drying and ventilation is working.
Moisture meter
Takes readings at three points on every rafter before and after removal. Anything above 20% is flagged in the report as needing attention or further drying time.
Air scrubber
Runs throughout the job to filter airborne dust and isocyanate particles from the loft air. Essential when working in a confined roof void above a occupied home.
Use cases
When Stafford homeowners call us
These examples show how the service framework adapts rather than forcing every call through one repair.

Wildwood loft restored for storage
A homeowner in Wildwood wanted to board the loft but every rafter was buried under 100mm of open cell foam. Damp patches had appeared on the bedroom ceiling below, and the loft was unusable for storage. → We cut and vacuumed the foam, cleaned the void and restored ventilation through the eaves. The ceiling damp patches dried out within three weeks. The loft was boarded a month later and is now used for storage.
Highfields rental lofts cleared in four days
A landlord in Highfields had three rental properties with open cell foam and damp patches on ceilings. A compliance inspection was due and the foam was blocking any assessment of the roof timbers. → We phased the work across four days, clearing each loft and issuing a separate report. Rot was found on two trusses and documented for repair. All three properties passed inspection with reports on file.
Problems we solve
Problems open cell foam removal in Stafford solves
Foam in a loft causes more trouble than most homeowners realise. These are the four problems we are called out for most often across Stafford and the surrounding villages.
Mortgage lender refuses to lend on a foam-filled roof
We remove the open cell foam, inspect the timbers and issue a written report your lender can accept. Most Stafford customers get a decision within days of the report landing. We have unlocked completions in Castlefields, Doxey and Rowley Park.
Hidden damp and roof timber rot behind the foam
We take moisture meter readings before and after extraction, and check every timber with a thermal imaging camera. Damp or rot is photographed and logged so you know exactly what needs fixing. Catching it early in a Stafford loft usually means treating timbers rather than replacing them.
Reduced loft ventilation causing condensation
We clear the foam, open the eaves and restore the ventilation path through the roof void. A thermal imaging check confirms airflow before we leave. Customers in Baswich and Wildwood have seen ceiling damp patches dry out within weeks of extraction.
Loft unusable for storage or future insulation
Once the foam is out and the void is cleaned, the loft is ready for boarding, new insulation or a roof repair. We leave it clean enough to walk through in normal clothes. Most Stafford customers board their loft within a month of removal.
Pricing process
What foam removal costs in Stafford
1,200 - 3,500 pounds depending on loft size, foam depth and access
Loft size and foam depth
A 40 square metre loft with 100mm of foam is the standard job and sits in the middle of our range. Larger roofs or foam over 150mm deep take longer and cost more. We measure both during the free survey.
Roof access and headroom
Shallow pitches and tight eaves slow the work down. If we cannot stand upright, extraction takes longer and the price reflects it. We check access during the survey so there are no surprises on the day.
Foam type and condition
Open cell foam comes out faster than closed cell. If your loft has a mix, we quote for each section separately. Foam that has been in place for decades and bonded tightly takes longer to remove.
How much does open cell spray foam removal cost in Stafford?
Most Stafford lofts cost between 1,200 and 2,400 pounds in 2026, with larger roofs or difficult access running to 3,500 pounds. Price depends on foam depth, roof size, and whether the timbers need extra cleaning. The survey and written quote are free, and the figure does not change unless we find something the survey missed. Call 0333 567 2543 to book.
Can you remove open cell foam in Stafford?
Yes. We remove open cell spray foam across Stafford and Staffordshire, including Icynene, Lapolla and Demilec products. Open cell foam is softer than closed cell, so it comes off with an oscillating multi-tool and industrial scraper, then goes into a spray foam removal vacuum. A standard loft takes four to six hours. We cover Baswich, Wildwood, Highfields and the surrounding villages.
Is open cell foam extraction available in Staffordshire?
Open cell foam extraction Stafford Staffordshire is available seven days a week, with same-day quotes and same-week bookings. We cover Stafford town centre, Baswich, Weeping Cross, Wildwood, Rising Brook, Silkmore and out to Derrington and Littleworth. If you are outside those areas, call us and we will confirm cover before you book.
Will removing the foam damage my roof?
No, when it is done properly. We use dry ice blasting on delicate felt and battens, which freezes the foam so it releases without tearing. An oscillating multi-tool handles the bulk of the foam, and we check every rafter with a moisture meter afterwards. If we find rot underneath, we photograph it and tell you exactly which timbers need repair before we finish.
Ready when you are
Book open cell spray foam removal in Stafford
If a lender or surveyor has flagged your loft foam, call us today on 0333 567 2543. We will book a free survey, give you a fixed price, and clear the foam with a written report for your file. Fully insured, CHAS accredited, and based right here in Stafford.

Talk with the local team
Request open cell spray foam removal
Ring 0333 567 2543 any time, day or night, and you will speak to someone who knows Stafford roofs. For non-urgent jobs, email us a photo of the foam and we will come back with a survey slot, usually within one working day. We cover the whole of Stafford and Staffordshire.


