Thermal imaging, moisture readings and a written verdict in one visit
Insulation assessment in Stafford, Staffordshire you can act on
An insulation assessment in Stafford, Staffordshire tells you exactly what is behind your plasterboard, under your loft boards and inside your cavity walls. We check spray foam, damp, timber and ventilation, then hand you a clear report you can take to a lender, a buyer or your own builder. Most Stafford homes we see were insulated between 1965 and 2005, and time has not been kind to a lot of it.
Live phone supportUpfront optionsBacked workmanship
What's included
What is included in the assessment
Every insulation assessment in Stafford includes the same core checks, whether you have a small loft or a full commercial building. Here is what you get as standard, and what we would quote separately if it turns out to be needed.
Thermal imaging survey
We use a thermal imaging camera to map heat loss and cold bridges across walls, ceilings and roof slopes. This shows us where insulation is missing, compressed or wet without lifting every board. You get the images in your report.
Moisture readings
A moisture meter gives us percentage readings at multiple points on timbers, plaster and substrates. Anything above 20 percent is flagged. We record the readings so you can compare them after any remedial work.
Foam type identification
We identify whether you have open cell spray foam, closed cell spray foam or a mix, and note the brand where visible. Icynene, Lapolla, Demilec, BASF and Huntsman products all behave differently, and that affects the advice we give.
Ventilation check
We inspect eaves, soffit vents and any roof space ventilation to see whether air is moving as it should. Reduced loft ventilation is the most common cause of foam-related damp, and it is often fixable without removing anything.
Written report and photos
Within 48 hours you receive a report with photographs, readings, foam identification and a clear recommendation. If removal is needed, the report includes a scope and fixed price. If it is not, we tell you that too.
Service overview
What an insulation assessment in Stafford, Staffordshire actually involves
An insulation assessment in Stafford, Staffordshire is a forensic inspection of the insulation already in your property, covering open cell spray foam, closed cell spray foam, mineral wool, board and loose fill. We use a thermal imaging camera to map cold bridges, a moisture meter to check timber and plaster, and a boroscope to look behind fixed panels. You get photographs, readings and a plain-English verdict on whether the insulation is doing its job or quietly causing damage.
Stafford sits in a damp, cool climate and its housing stock is a mix of Victorian terraces, 1930s semis and 1970s estates. That combination is where hidden damp, roof timber rot and reduced loft ventilation show up most. If you have been refused a mortgage because a surveyor flagged spray foam, an insulation survey Stafford Staffordshire buyers and lenders accept is usually the first thing you need. We also cover insulation assessment Baswich Stafford and the surrounding wards.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How our insulation assessment works
The process flexes to the condition, but these checkpoints keep decisions clear.
Phone triage
You call 0333 567 2543 and we ask the right questions: property age, where the foam is, whether a lender or surveyor is involved. That call takes ten minutes and tells us whether you need a full assessment or a targeted check. We book you in for a slot that suits, including evenings.
On-site inspection
We arrive with a thermal imaging camera, moisture meter and boroscope. Expect 60 to 90 minutes for a typical three-bed semi. We check the loft, eaves, cavity walls where accessible, and any area a surveyor has flagged. You are welcome to watch and ask questions as we go.
Testing and sampling
We take moisture readings at multiple points, check foam type by texture and colour, and look for isocyanate odour or crumbling that suggests a failed mix. Where needed we lift a small section of boarding to inspect the substrate underneath. Nothing is disturbed that we cannot put back the same day.
Written report
Within 48 hours you receive a report with photographs, meter readings, a foam type identification and a clear recommendation: leave it, ventilate it, or remove it. If removal is needed, the report includes a scope and a fixed price so there are no surprises later.
Follow-up call
We ring you once you have had time to read the report. If your lender or surveyor has questions, we will speak to them directly. If you decide to go ahead with removal, we book the work at that point and confirm the date in writing.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Thermal imaging camera
Maps temperature differences across walls, ceilings and roof slopes to reveal missing insulation, cold bridges and areas where foam has failed or become wet.
Moisture meter
Gives percentage readings on timbers, plaster and substrates. Anything above 20 percent is flagged as a damp risk and recorded for comparison after remedial work.
Boroscope
A flexible camera that lets us see behind fixed panels, under floorboards and inside cavities without dismantling the building. Essential for checking foam in awkward spaces.
Respirator
Protects our technicians from isocyanate vapours and airborne particles when inspecting or removing spray foam. We also carry spare masks for occupants if needed.
Air scrubber
Filters airborne dust and chemical odours during assessment and removal work. Keeps the property habitable and protects occupants with breathing sensitivities.
Use cases
When to book an insulation assessment
These examples show how the service framework adapts rather than forcing every call through one repair.
Cold loft fixed without removal in Wildwood
A homeowner in Wildwood complained that their loft conversion was cold despite spray foam being installed. They assumed the foam had failed and expected a removal quote. → Thermal imaging showed the foam was performing well but had been sprayed over the eaves vents, blocking airflow and causing condensation. We cleared the vents, added two new ones, and the condensation stopped. The homeowner saved the cost of removal.
Damp roof timbers caught early in Rising Brook
A landlord in Rising Brook noticed a damp smell in the loft of a rental property. The foam had been installed years earlier and the tenant had reported condensation on the roof felt. → Moisture readings showed 22 percent in three timbers, just above the safe threshold. We removed the closed cell foam using dry ice blasting, dried the timbers and treated them. The loft was dry within a fortnight and the tenant stayed in the property throughout.
Problems we solve
Problems our insulation assessment in Stafford solves
Most calls we get are about one of these four issues. Each one has a different answer, and the assessment is how we work out which applies to your property.
Mortgage lender refusal over spray foam
We assess the foam, document its condition and produce a report your lender can act on. If removal is required, we quote it from the same report so there is no gap between assessment and remediation.
Hidden damp in roof timbers
Our moisture meter readings catch damp early. We identify whether the source is foam trapping moisture, blocked ventilation or a roof leak, and we tell you which fix is needed.
Reduced loft ventilation
We check airflow at every vent point and identify which ones are blocked. Often the fix is clearing or adding vents rather than removing foam, which is a fraction of the cost.
Health concerns from isocyanates
We check for odour, crumbling foam and failed mix signs during the assessment. If the foam is off-gassing, we advise on removal and use air scrubbers and respirators to carry it out safely.
Pricing process
Insulation assessment cost in Stafford
180 - 350 pounds for residential assessments, commercial quoted on site
Property size
A three-bed semi takes 60 to 90 minutes to assess. Larger detached homes, properties with multiple roof spaces or commercial buildings take longer and are priced accordingly.
Access difficulty
Lofts with restricted access, low headroom or foam in awkward spaces take more time. We will tell you on the phone if your property is likely to be at the higher end.
Number of areas
Assessing a loft only is cheaper than assessing a loft, cavity walls and a roof. If you need multiple areas checked, we quote for the whole scope upfront.
How much does insulation assessment cost in Stafford?
Most residential assessments in Stafford cost between 180 and 350 pounds depending on property size and access. A standard three-bed semi with a loft and cavity walls sits at the lower end. Larger detached homes, commercial units or properties needing multiple areas inspected run higher. The fee is fixed before we visit, and it includes the written report and a follow-up call.
Do you provide insulation survey in Stafford?
Yes. An insulation survey Stafford is the same visit as an assessment, just described in the language lenders and solicitors tend to use. We inspect the foam, test for moisture, check ventilation and produce a report that states whether the insulation is compliant, causing damage, or safe to leave in place. We cover all Stafford postcodes and the surrounding villages.
Is insulation assessment available in Staffordshire?
Yes, we cover the whole of Staffordshire from our Stafford base. That includes Baswich, Weeping Cross, Wildwood, Rising Brook, Doxey, Derrington and out towards Stone, Penkridge and Rugeley. Travel within 20 miles of Stafford is included in the quoted fee. Anything further is agreed on the phone before booking.
Can you assess spray foam before I buy a house?
Yes, and it is one of the most common reasons people call us. If a surveyor has flagged spray foam on a property you are buying, we can inspect it before exchange and tell you whether it is a problem, a nuisance, or a non-issue. That report often gives buyers the leverage to renegotiate or the confidence to proceed.
Related services
Related Services
Spray Foam Removal near me
If your assessment shows the foam has to come out, we handle the removal ourselves. No subcontractors, no handover gaps. We quote from the same report you already have, so the price you were given for removal is the price you pay.
same day Spray Foam Removal
When a lender or buyer needs foam gone quickly, we can sometimes carry out removal the same day as the assessment. It depends on access and foam type, but for small loft areas it is often possible. Call us to check availability.
24/7 Spray Foam Removal
Commercial clients and landlords sometimes need work done outside business hours. We offer evening and weekend slots for removal, which keeps tenants undisturbed and lets retail or warehouse units stay operational during the day.Ready when you are
Book your insulation assessment in Stafford, Staffordshire
One visit, a written report in 48 hours, and a straight answer on whether your insulation is safe to leave. Call 0333 567 2543 and we will book you in, usually within the same week.
Talk with the local team
Request insulation assessment
Ring 0333 567 2543 any time, day or night, and you will speak to someone who knows Stafford roofs. For non-urgent jobs, email us a photo of the foam and we will come back with a survey slot, usually within one working day. We cover the whole of Stafford and Staffordshire.